Models
>
MDC4650AWW
MDC4650AWW Maytag Dishwasher - Overview
Sections of the MDC4650AWW
[Viewing 9 of 9]Manuals & Care Guides for MDC4650AWW
Click to downloadKeep searches simple, eg. "belt" or "pump".
Dishwasher Door Handle And Latch Assembly with Switch
PartSelect #: PS11748729
Manufacturer #: WPW10130695
$63.14
In Stock
Silverware Basket - Gray
PartSelect #: PS11743069
Manufacturer #: WP6-918873
This part has been redesigned by the manufacturer and is now a complete full basket with a handle and covers.
$35.27
In Stock
Lower Wheel Assembly
PartSelect #: PS11747717
Manufacturer #: WP99002780
This lower dishrack roller is less than two inches in diameter. It is made entirely of plastic.
$15.84
In Stock
Faucet Adapter
PartSelect #: PS11751238
Manufacturer #: WPW10254672
Used with some portable dishwashers and washers. NOTE: As per the factory, this is used for faucets with inside or outside threads. For female connection (outside) just remove the washers.
$69.23
In Stock
Door Latch with Switches - NO Handle
PartSelect #: PS11751688
Manufacturer #: WPW10275768
This is the door latch and switches only. The handle is not included with this part.
$71.53
In Stock
Wash Impeller
PartSelect #: PS11747701
Manufacturer #: WP99002659
This impeller rotates and is used to force water up through to the spray arm.
$81.57
In Stock
Accumulator Filter
PartSelect #: PS11749941
Manufacturer #: WPW10192799
This part is essential in your dishes getting clean during the wash cycle. If there is any debris or a tear in the filter, it can cause extra buildup and, therefore, causing dirty dishes.
$173.77
In Stock
Door Cable Link
PartSelect #: PS11747772
Manufacturer #: WP99003446
Sold individually.
$14.16
In Stock
Inner Door Foam Insulation Strip
PartSelect #: PS11748543
Manufacturer #: WPW10117748
This inner door insulation seal is almost twenty-four inches long. It is gray in color and is made of a foam material.
$46.03
In Stock
Screw
PartSelect #: PS12349731
Manufacturer #: W11233072
This is a multi-use and multi-appliance screw. It can be used on a microwave, refrigerator, range/oven, air conditioner, dehumidifier, washer, or dryer. The measurements of this screw are 8 x 1/2 inch...
$26.43
In Stock
Docking Station with Flappers
PartSelect #: PS2340934
Manufacturer #: 6-917647
The docking station is located on the water supply tube at the far back. It provides water to the upper and middle spray arm and also includes the flappers.
No Longer Available
Wash Arm Cap
PartSelect #: PS11747698
Manufacturer #: WP99002654
This part is the replacement wash arm cap, also known as the spray arm nut, for your dishwasher. It is made of white plastic and is approximately ½ an inch in diameter. The wash arm cap fastens the lo...
$14.68
In Stock
Questions And Answers for MDC4650AWW
We're sorry, but our Q&A experts are temporarily unavailable.
Please check back later if you still haven't found the answer you need.
- < Prev
- 1
- Next >
Sort by:
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing answers that matched.Try using some different or simpler keywords, or submit your new question by using the "Ask a Question" button above!
Virginia
February 7, 2023
Need faucet hook up for portable dish washer…
For model number MDC4650AWW
Hello Virginia, Thank you for contacting us. Researching the model number that you have provided, all versions of this model show the faucet adaptor as part# PS11751238. We hope this helps you.
Was this helpful?
Thank you for voting!
Related Parts:
- < Prev
- 1
- Next >
Common Symptoms of the MDC4650AWW
[Viewing 11 of 11]Door latch failure
Fixed by
these parts
these parts
Show All
Not cleaning dishes properly
Fixed by
these parts
these parts
Show All
Leaking
Fixed by
these parts
these parts
Show All
Will Not Start
Fixed by
these parts
these parts
Show All
Door won’t close
Fixed by
these parts
these parts
Show All
Not draining
Fixed by
these parts
these parts
Show All
Noisy
Fixed by
these parts
these parts
Show All
Will not dispense detergent
Fixed by
these parts
these parts
Show All
Will not fill with water
Fixed by
these parts
these parts
Show All
Not drying dishes properly
Fixed by
these parts
these parts
Show All
Touchpad does not respond
Fixed by
these parts
these parts
Show All
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Broken latch handle
The hardest thing was figuring out that you only need to purchase the latch handle because it only comes as a complete latch assembly, why they even list the latch assembly as a separate part in the parts list stupid. (you get the handle and latch already put together and it cost less than the latch assembly without the handle). Anyway all you need to do is disconect the power from the dishwasher (unless you like to live dangerously like me) take your drill with the correct size torx bit and remove all the screws on the inside door pannel (the top center two screws actually hold the latch assembly in place). Disconect the 4 wires from the old part and reconect them to the new part and reinstall all the torx screws being careful not to strip the plastic threads that they screw into if you are using a drill. Whole process takes less than 5 minutes. I am surprised that Maytag used such a flimsy handle assembly in their dishwashers since they are supposed to have the repair men with the most time on their hands. They probably sell just as many handle assemblies as they do dishwashers that have this particular part in it, probably more since you will probably have to change it 2 or 3 times during the life of the unit.
Parts Used:
-
Walter from Tucson, AZ
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
-
Tools:Screw drivers
1080 of 1116 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Handle jammed and door wouldn't open on Maytag Quietseries 100 dishwasher
I Followed others' instructions already posted to replace the whole handle assembly. In particular, use a big screwdriver placed against the bottom of the handle and whack the grip with the palm of your hand to get the handle to move back to the open position so you can open the door and start the job. I am no handyman, but this fix was easy, about 30 minutes in all, most of which was spent figuring out which breaker to pull so as not to get shocked. One note of caution: use the correct screwdriver attachment (not a Phillips head or regular, but a star or something- see I am not a handyman but I do have a $15 screwdriver set that just paid for itself 10 times over!).
Parts Used:
-
Philip from Carlsbad, CA
-
Difficulty Level:Easy
-
Total Repair Time:15 - 30 mins
-
Tools:Pliers, Screw drivers
571 of 588 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Door release latch handle was broken. The handle was deeply recessed into the door and the door was difficult to open.
Remove the 8 or 9 torx screws holding the inner and outer door assembly together (leave the bottom screws in), lift the old handle assembly out, transfer the switches to the new handle assembly, and reassemble door.
Parts Used:
-
Dave from Livonia, MI
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
547 of 554 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!