Troubleshooting
This part fixes the following symptoms:
Will not drain
This part works with the following products:
Washer.
This part works with the following products:
Maytag.
Part# WPW10321032 replaces these:
AP6019462, W10321032
Customer Reviews
Filter By Rating:
- < Prev
- 1
- Next >
Sort by:
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing reviews that matched. Try using some different or simpler keywords.
Ivan F - June 1, 2023
Verified Purchase
Drain Pump Replacement
Perfect replacement part. 15 minutes job. Thanks so much.
Richard K - January 14, 2019
Verified Purchase
very easy repair, 15 minutes start to finish
part came in quite fast considering it was ordered in the Christmas break. Simple fix, machine works great again
Andy D - August 10, 2018
Verified Purchase
Worked as expected
Perfect
- < Prev
- 1
- Next >
Questions and Answers
We're sorry, but our Q&A experts are temporarily unavailable.
Please check back later if you still haven't found the answer you need.
- < Prev
- 1
- Next >
Sort by:
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing answers that matched.Try using some different or simpler keywords, or submit your new question by using the "Ask a Question" button above!
Scott
September 14, 2017
Machine first shows a sud error, I know what this means. Machine clears itself, and then will show error code e01 followed by f09. This is while the machine is running empty. I cleaned all hoses leading to the pump, and also the drain hose. Tried machine, codes still flash. Two technicians looked at this machine saying its fine.. wrong. I installed a new pump... machine still flashes same error codes. All hoses are clean, new pump installed... What is my next step to solving this problem.. New mother board? This is a front end loader. Model # is mhw6000xg1.. When searching this, states incorrect model #.. this is what is on the sticker located behind the door.
For model number MHW6000XG1
Hi Scott,
Thank you for the question. When the washer goes into the drain cycle and the drain time is over 8 minutes and not reaching the reset level in the pressure switch then the drain pump will stop pumping out the water. This means there is a possible issue in the Drain pump, Pressure Switch, or the Electronic Control Board.
Since the pump has already been replaced you will need to look into the Pressure Switch Part number PS11752436 or the board PS6447843.
Hope this helps!
1 person found this helpful.
Was this helpful?
Thank you for voting!
Related Parts:
Michael
January 20, 2018
Should the impeller on the water pump have some play “wiggle room” or should it stay rigid with impeller axle? I’ve notice evidence of wear and was curious if the reason my washer wont drain is due to pump impeller damage
For model number Mhw6000xw2
Hello Michael, Thank you for your inquiry. There may be a little room but not very much. If the impeller shows signs of wear, you should probably replace the pump. Hope this helps!
Was this helpful?
Thank you for voting!
- < Prev
- 1
- Next >
Related Parts
Model Cross Reference
This part works with the following models:
PartSelect Number: PS11752769
Manufacturer Part Number: WPW10321032
Manufacturer Part Number: WPW10321032
Brand
Model Number
Description